In 1972, the company KERMI was collected, unique, in accordance with the time line for the automatic production of steel radiators, which embody the reliability and constant introduction of new technologies in the production of heating appliances KERMI.

  Through constant innovation and development four years ago, there were radiators Kermi uprated productivity and profitability: the deadline for their heating down by one quarter, energy consumption decreased by 11%, and the strength of the radiation up to 100%, compared to other panel heating devices. Note that this result was achieved through the introduction of the system, known as Therm X2.

  To have an idea of the system, need a little dive into the construction equipment. Steel, panel radiators Kermi represent, from a joint panel of two tubes through which coolant is circulated. In conventional radiator heating is uniformly, in other words coolant enters at the same time on both panels. It is no secret that until nadavnego time, this method of heating is the most rational.

  Steel panel radiators Kermi, technology Therm X2, arranged so that the coolant in them previously held the front panel, and only then goes to the rear. Indeed, because of this can quickly heat up the front of the radiator and to increase the intensity of the radiation. In the back cover comes slightly chilled coolant, it is heated longer and does not reach such high temperatures, as the front. This is not a fault, but the dignity, this time back panel effectively acts as a screen, which prevents heat loss, and almost none of, valuable energy for no one desired heating of the wall, as with other heating devices.

Lateral connecting of FKO (240)
Lower connecting of FTV (FKV) (240)